*** We are still accepting and shipping orders at this time. We will update this message if we have to close due to COVID-19. Stay safe! ***
Australia Post is experiencing delays due to a significant increase in shipping volume. Express Post guarantee has been temporarily suspended. Please be aware that packages may experience delivery delays.

PT100 Temperature Sensor (E3D)

Out Of Stock PT100 Temperature Sensor (E3D)

PT100s are high temperature, high accuracy temperature sensors that you can now use on your E3D V6 HotEnd instead of a thermistor or thermocouple. PT100's are able to measure higher temperatures than thermistors - up to 400°C and are more accurate then both thermistors and thermocouples in general. Our PT100 sensors are also very easy to handle, being of a metal cartridge type construction that is secured with a set screw, no more fibreglass sleeving or clamping washer.

These PT100 sensors fit in E3D Hotends that take cartridge-style thermistors, including currently-shipping E3D V6, Lite6 and Chimera. Older versions of these hotends (the thermistor clamping style) are not compatible - but you can grab the updated heater block to make them work (see the related items).

Please be aware that a PT100 is not the same as a thermistor and unless your electronics explicitly supports RTD Sensing devices you will need an amplifier board. 

The Ultimaker 2 uses PT100 sensors by default, and this sensor allows you to connect your E3D Hotend and Ultimaker electronics with no alteration to the electronics or firmware of the Ultimaker 2. 

What's Included:

  • 1 x PT100 Cartridge Temperature Sensor
  • 1 x 100cm Cable

Write a review

Note: HTML is not translated!
    Bad           Good

Genuine E3D-Online Product

Sourced direct from E3D-Online in the UK

  • Brand: E3D
  • Product Code: E3D-TEMP-CART-PT100
  • Availability: Out Of Stock
  • $29.95
  • Ex Tax: $27.23