Melzi 2.0 Control Board - ATmega1284P
RepRap Melzi Ardentissimo control boards are full-featured, all-in-one control boards suitable for a wide range of 3D printer builds. This board features four integrated A4988 stepper drivers, three MOSFETs for heated beds, HotEnds or fans, and an on-board microSD card socket.
These are the same Melzi control boards we used in our 2014/2015 Prusa Mendel i3 kits. They're neater to wire than a RAMPS-based setup, and don't take up as much space vertically. Unlike RAMPS, these boards aren't modular, and can't be easily upgraded - so there is a tradeoff for the neater installation.
For more information, including setup and wiring information, see the RepRap wiki page on Melzi.
- 12V Power Input
- 4 x A4988 Stepper Drivers
- 3 x 12V MOSFETs
- Integrated microSD Socket