Control Boards

Control Boards
Show:
Sort By:

Graphic LCD Controller + SD Card Reader for RAMPS

The Graphic LCD Controller is a graphical user interface to control your 3D printer without the need..

$34.95 Ex Tax: $31.77

IR Z Probe 1.3

These 3D Printer Z-Probes use modulated infra-red LEDs to accurately detect proximity to the print s..

$39.95 Ex Tax: $36.32

IR Z Probe 1.4

These 3D Printer Z-Probes use modulated infra-red LEDs to accurately detect proximity to the print s..

$39.95 Ex Tax: $36.32

LCD Controller + SD Card Reader for RAMPS

The Smart Controller is a graphical user interface to control your 3D printer without the need of a ..

$27.45 Ex Tax: $24.95

Melzi 2.0 Control Board - ATmega1284P

RepRap Melzi Ardentissimo control boards are full-featured, all-in-one control boards suitable for a..

$54.95 Ex Tax: $49.95

MightyFan - RAMPS Fan Expansion Board

MightyFan is TinyFan's bigger brother. It does the same job - it lets you add extra controlled fans ..

$26.95 Ex Tax: $24.50

OctoPi Raspberry Pi Complete Pack / Kit

This is a complete kit to get an OctoPi installation up and running - take control of your 3D p..

$164.95 Ex Tax: $149.95

RAMPS 1.4 Printer Control Board

This is a RepRap Arduino Mega Pololu Shield - commonly known as a RAMPS board. These boards are vers..

$25.25 Ex Tax: $22.95

RUMBA+ Control Board

If you're looking for a something to step up from an entry-level set of RAMPS electronics, then look..

$169.95 Ex Tax: $154.50

Stepstick - A4988 RepRap Stepper Motor Driver

These stepper drivers – or StepSticks – are designed to connect to a RAMPS board in order to power a..

$6.95 Ex Tax: $6.32

Stepstick - DRV8825 RepRap Stepper Motor Driver

These stepper drivers are built around TI's DRV8825 stepper driver IC. The DRV8825 supports higher c..

$7.95 Ex Tax: $7.23

TinyFan - RAMPS Fan Expansion Board

TinyFan is a handy little board that attaches to RAMPS, and allows you to control an extra two fans...

$16.95 Ex Tax: $15.41